Codes for the GE Universal Remote for Direct TV
Ge Universal remote controllers may be set to control many devices such as TVs, Blu-ray players, and AV receivers, allowing you to replace multiple remote controls with only one Ge Universal remote.
You Asked, We Answered
All home theatre equipment and components can be controlled with the Ge remote. The Ge Universal remote allows you to replace all of your devices remotes with a single Ge remote.
You may begin using the Ge universal remote by programming it with each individual item in your home theatre arsenal.
Before you begin, double-check that all of the wires are connected and that all of the devices and components are turned on. After that, check to see if the remote’s batteries are working.
GE Universal Remote for Direct TV
What are the GE 6 Universal Remote Codes and Program Steps?
Directv Dvr Code for GE Remote
DirecTV VCR code for GE remote
GE Universal Remote Codes for Samsung TV With Program Method
Setup and Instructions for GE Universal Remote Codes
Here are the complete steps to get the Universal Remote Codes for Direct TV:
Step 1: Turn on the device and go into setup mode.
On the GE universal remote control, look for the SETUP button. Hold down the setup button until the red light turns on. Then release the setup button. The remote has switched to setup mode.
Step 2: Select the device you wish to set up by swiftly pressing and releasing the device button. For example, if you’re programming a television, press and release the TV button.
Step 3: Choose the universal remote code that corresponds to your device from the list below.
The red light will turn off after you enter the universal remote code on the number keypad.
Step 4: Confirm the outcomes.
To turn the on and off the device, point the GE Universal remote in the direction of the device. You’re good to go if the device responds. Otherwise, repeat the process with the next four-digit code from the list below.
Step 5: Configure the other device.
Repeat the steps above to set up additional devices.
GE 4 digit codes SAT DTV WebTV universal remote controls:
Are you looking for a complete solution for GE’s 4 digit codes? So here we have a complete list of codes given below:
1. How can I set up my universal remote to control my cable box?
Turn on the gadget you want to operate manually. Press and hold the SETUP button for approximately 4 seconds, or until the red indicator light stays on. On the remote, press and release the desired device button (TV, DVD, SAT, AUX). The red indicator will blink once before remaining illuminated.
2. Without a code, how can I program a universal remote?
Hold the Power button and the button for the device you wish to program your remote for at the same time. When prompted, release both buttons. You can release the item’s button and the Power button once the LED light on your remote control turns on and stays on.