Jbl Soundbar Remote Codes& Jbl Remote Control Programming

To program your remote control you need 4-digit and 5-digit codes which are given below. As well as you also get all the programming methods to program your remote control.

JBL Soundbar 4-digit  Remote Codes:

6050

4001

5009

JBL soundbar 5-digit remote codes:

30281

30110

32241

31306

If you having a problem with these codes then have to use codes search through your “CAB” or “SAT” remote control.

Philips Universal Remote 4 Digit Codes List & Program Method

Jbl Remote Control Programming Code Search Through Comcast Remote Control:

Step 1: “ON” your soundbar.

Step 2: Then you will see the “AUX” button. You have to press this button.

Step 3: Now, you have to go for the “SETUP” button from your remote control. And press it. Till the remote control indicator is not lit.

Step 4: After, this release the “SETUP” button.

Step 5: Now, you have to enter this code “9-9-1-3” or “9-9-3”.

Step 6: Now, you get an indication from the “AUX” button. Which is blinked twice.

Step 7: Now, again you have to press the “POWER” button from your remote control.

Step 8: Now, you have to press the “VOL+” button. Unitll the soundbar turns “OFF”.

Step 9: Now, you get an “IR” code which is sent by the library of the remote control.

Step 10: Now you have to press and hold the “SETUP” button to lock the codes.

Step11: Now, the “AUX” button will blink again twice.

Jbl Remote Control Programming Code Search Through Directv Remote Control:

How to Get GE Universal Remote Codes & Program Instructions

Step 1: “ON” your device.

Step 2: Press the “VOLUME” button until the volume of the device not getting full. Then press the “MUTED” button from the remote control.

Step 3: Now, you have to press any “AV1” or “AV2” button from your remote control.

Step 4: Now, you have to press and hold the “MUTE” button and the “SELECT” button. Until you didn’t get the indicator light that blinks “twice”.

Step 5: Now, you have to enter this code and wait until you get an indication from the remote control “9-9-1”. And press the “ENTRE” button after dialing the code.

Step 6: Now, you have to press the “VOL-“ button.

Step 7: Do the same thing with the “CH+” button.

Step 8: After this, you have to tap on the “SELECT” button.

If all the function is able to work as according to then your remote control is programmed.

Back to top button